Screen Print Transfers
Heat Transfer Vinyl by Siser and is printed with eco-solvent ink, Cut Out, and ready to press. A sheet of transfer is included with each order.
These are Ready To Press with a transfer sheet already applied to the Design. All you have to do is remove the backing and apply it to your shirt.
APPLICATION
Pre-Heat fabric 3-5 seconds, this will remove any moisture that may be in the fabric that could cause the vinyl to leave after washing. Pre-heating should be done on ALL heat vinyl projects.
Iron or Heat Press for 15 Seconds at 315F at Medium Pressure (don't forget to cover with a Teflon sheet or pillowcase to protect the masked transfer from the top of the heat press or iron). Additional masking sheets are available in a separate listing if one is needed.
TO ADHERE:
1. Weed excess vinyl from around the design. Weeding is very easy with Siser printable vinyl and everything has cut lines, all you need is a weeding tool or something with a sharp point to it.
2. Once weeded, place mask (clear sticky sheet) on to transfer and firmly press across to remove any bubbles. Sometimes it's easier to place the mask on the table with the sticky side up and starting at the bottom, take one end of the transfer and lay down while slowly running your hand across while laying down the rest of transfer.
3. After you have firmly pressed mask onto the design and removed bubbles, flip transfer over to where the design is facing down and starting at a corner, slowly peel the carrier sheet that the design is attached to up off of the carrier
4. Once off of the carrier, place transfer on the garment, cover with Teflon sheet, and iron or press.
ADHERES TO
*100% Cotton
*Poly/Cotton blends
*100% Polyester
*Leather
*Lycra/Spandex
CARE INSTRUCTIONS
*Do not dry clean
*Wash inside out
*Machine wash w/mild detergent
*Wait 24 hours before first wash
*Dry on normal setting
NO returns on any transfers.
These are Ready To Press with a transfer sheet already applied to the Design. All you have to do is remove the backing and apply it to your shirt.
APPLICATION
Pre-Heat fabric 3-5 seconds, this will remove any moisture that may be in the fabric that could cause the vinyl to leave after washing. Pre-heating should be done on ALL heat vinyl projects.
Iron or Heat Press for 15 Seconds at 315F at Medium Pressure (don't forget to cover with a Teflon sheet or pillowcase to protect the masked transfer from the top of the heat press or iron). Additional masking sheets are available in a separate listing if one is needed.
TO ADHERE:
1. Weed excess vinyl from around the design. Weeding is very easy with Siser printable vinyl and everything has cut lines, all you need is a weeding tool or something with a sharp point to it.
2. Once weeded, place mask (clear sticky sheet) on to transfer and firmly press across to remove any bubbles. Sometimes it's easier to place the mask on the table with the sticky side up and starting at the bottom, take one end of the transfer and lay down while slowly running your hand across while laying down the rest of transfer.
3. After you have firmly pressed mask onto the design and removed bubbles, flip transfer over to where the design is facing down and starting at a corner, slowly peel the carrier sheet that the design is attached to up off of the carrier
4. Once off of the carrier, place transfer on the garment, cover with Teflon sheet, and iron or press.
ADHERES TO
*100% Cotton
*Poly/Cotton blends
*100% Polyester
*Leather
*Lycra/Spandex
CARE INSTRUCTIONS
*Do not dry clean
*Wash inside out
*Machine wash w/mild detergent
*Wait 24 hours before first wash
*Dry on normal setting
NO returns on any transfers.